Creation

Not a day without a gadget: a travel case for a laptop

Pin
Send
Share
Send

A wonderful and stylish accessory for storage, protection and convenient transportation of the laptop. Our model has an additional pocket for cable, headphones and a notebook with a pen.

Important!

If the size of our case does not fit the size of your laptop, then take measurements from your laptop and cut out the details of the right size.

In the pocket of the case there is enough space to store the most necessary accessories for your favorite gadget.


DIY laptop bag


You will need:

- cotton fabric with print;

- ramie fabric for lining;

- non-woven H 640;

- threads for sewing;

- ready slanting inlay;

- a manual needle for sewing;

- tailor pins;

- scissors;

- ruler for patchwork;

- tape measure;

- trick marker;

- clothes pegs;

- ruler

Step 1. Cutting

Printed cotton fabric:

- outer part measuring 116 x 36 cm;

- internal part (valve) measuring 27 x 36 cm.

From ramie fabric:

- lining 47 x 36 cm.

Gasket (non-woven H 640):

detail 72 x 34 cm

Step 2

Stitch the short side of the lining (36 cm long) to the inner part (27 x 36 cm in size) at a distance of 1 cm.

Iron seam allowances on the lining and stitch on the front side close to the seam.

Step 3

Measure 25 cm along the outer part (116 x 36 cm in size), draw a line from the wrong side and fold the part along this line with the wrong side out.

Iron the fold.

Stitch the part close to the fold.

From the bend on the front side, measure 22 cm, bend and stitch it in the same way.

Step 4

Fold the pocket (see step 3) and stab it with tailor pins, relying on the diagram to step 1.

From the seamy side of the part, iron the gasket (at the same time, tissue sections protrude 1 cm on the sides of the gasket).


DIY tablet case


Step 5

Knock off the outer part duplicated by the gasket (see step 4) and chop off the double part with the inner part (see step 2) from the wrong side to the wrong side.

Stitch the bottom.

Step 6

To fix, lay a line around the perimeter at a distance of 5 mm.

Step 7

Turn over both short sides (36 cm long) with slanting trims.

Step 8

Fold the part as a cover and surround both sides (46 cm long) with an oblique inlay.

Source and photo: Burda 6/2019

Pin
Send
Share
Send

Watch the video: They Call It An Invisible Laptop Stand. . (November 2024).